Job Assembly
191
Copy
3
îš„ Area Settings
Displays the [Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] screen. You can
specify up to three areas.
z
Refer to "Delete Outside/Delete Inside (Deleting Outside or Inside of the Selected Area)" (P.190).
îš„ Originals
When the original document is a 2-sided document, specify from which side the specified
area is to be deleted.
îš‹ Both Sides
Applies the settings to both sides of the document.
îš‹ Side 1 Only
Applies the settings to Side 1 of the document.
îš‹ Side 2 Only
Applies the settings to Side 2 of the document.
îš„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
z
If the [Original Orientation] setting differs from the actual document orientation, the machine may not
detect the top of the document correctly.
îš‹ Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
îš‹ Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of the
document is placed facing the left side (horizontal text).
[Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] Screen
This screen allows you to specify the area to be deleted. The area is defined by the
rectangle formed between the points X1,Y1 and X2,Y2. The origin point is the top right
corner of a document.
You can specify a value in the range from 0 to 432 mm for the width (X) and the length (Y)
in 1 mm increments.
z
Specify the 2 coordinates from the top right corner of the document.
z
When specifying multiple areas, the specified areas can overlap each other.
z
When [Reduce/Enlarge] is set, the specified area will be reduced or enlarged accordingly.
To Next Page
Loading...
Need help?
General
