Fax/Internet Fax Options
283
Fax
4
îš„ Sending to Folder (F Code Method)
When a folder is set on a remote machine, you can send a document directly to the folder
by specifying the F code (sub-address) and password (if set up) of the folder.
Obtain the F code (sub-address) and password of the remote folder in advance.
Example of specifying a destination:
F Code (sub-address):0 (to designate an F Code transmission) and the folder number of a
folder on the remote machine
Password (if set up):The password of the remote folder
îš„ Secure Polling (F Code Method)
When a folder is set on a remote machine, you can perform secure polling for the folder by
specifying its F code (sub-address) and password (if set up).
If you use your machine to perform secure polling for a folder on a remote machine, obtain
the F code (sub-address) and password of the target folder.
If you use a remote machine to perform secure polling for a folder on your machine, give
the following information.
F Code (sub-address):0 (to designate an F Code transmission) and the folder number of the
target folder
Password (if necessary):The password of the target folder
z
A file received in the folder can automatically be printed depending on the folder settings. For information on the folder settings,
refer to ""Configuring/Starting Job Flow" (P.442).
z
Depending on the report print settings, a Folder Report may not be printed even after a file is received in a
folder. For information on the Folder Report setting, refer to "Tools" > "Common Service Settings" > "Reports"
> "Folder Report" in the Administrator Guide.
z
For information on how to print files received in a folder, refer to "Printing Files in a Folder" (P.438).
Sending to Folder (F Code Method)
1 Select [F Code].
To Next Page
Loading...
Need help?
General
