Fuji Xerox DocuCentre-V C2265

Fax
242
Fax
4
z
When using a wildcard for the last digit
z
When using wildcards for the last two digits
Reference
z
When you specify address numbers, confirm that the corresponding fax numbers are correctly registered on the machine. For
information on how to register address numbers, refer to "Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
Note
z
The maximum number of recipients that you can specify at one time is as follows:
z
Using address numbers only: 600 locations. Using the numeric keypad in combination with address
numbers: 600 locations.
z
An address number is always displayed in four digits. If [Auto Validation of Speed Dial Entry] is set to
[Validate entry after a fixed time] in the System Administration mode, and for example when you enter "**",
"0" is automatically added to the beginning of the wildcards to display "00**". For more information, refer to
"Tools" > "Common Service Settings" > "Other Settings" > "Auto Validation of Speed Dial Entry" in the
Administrator Guide.
z
You can use wildcards only for the last digit or last two digits of address numbers. The following is not
available: "*100", "**10", and "1*00"
1 Press the <Speed Dial> button, and enter a 4-digit address number. Repeat this step for
each additional recipient.
How to Enter
Wildcard
Target Address Numbers The Number of Target
Addresses
000* 0001-0009 9
001* 0010-0019 10
010* 0100-0109 10
100* 1000-1009 10
How to Enter
Wildcard
Target Address
Numbers
The Number of Target
Addresses
00** 0001-0099 99
01** 0100-0199 100
10** 1000-1099 100
123
456
789
0
＃
C