FujiFilm NXT - 6 Setting up Fujitrax Verifier; Introduction; Required Items; Setting up and Running the Central Server

QD002-07 6. Setting Up Fujitrax Verifier
NXT Setup Manual 147
6. Setting Up Fujitrax Verifier
6.1 Introduction
Fujitrax Verifier is used to perform two main functions. The first main function is feeder/part
verification. The other major function is parts management. There are many other
functions available through Fujitrax Verifier, however these will not be covered in this
manual. For information on Fujitrax functions, refer to the Fujitrax Verifier Operation
Manual.
Fujitrax Verifier must be properly set up and running before performing the steps in this
chapter to connect to the NXT machines. Follow the steps below to set up an already
installed and configured Fujitrax system to work with the NXT. Setting up and configuring
a complete Fujitrax is not covered in this chapter. For details on setting up and configuring
Fujitrax Verifier or more details on the items covered in this chapter, refer to the Fujitrax
Verifier Operation Manual.
6.2 Required Items
In order to use Fujitrax Verifier with the NXT, there are several required items.
• Fujitrax Verifier Central Server must be installed and running on the computer
with the Kit Server.
• The NXT must be added to the line configuration for the computer with the Kit
Server.
• The NXT Fujitrax configuration setting must be turned on.
• The NXT user must be added to the Kit Handy Settings when using Kit Handy.
Follow the procedures below to perform these actions.
6.2.1 Setting up and running the Central Server
The Central Server requires no special installation steps when installing the Kit Server.
This software is automatically installed when a compatible Kit Server version is installed on
a computer. However, the settings for the Central Server must be specified such as the
master database service name. This software should always be running whenever the
computer is on because it is a service.
1. On the computer with the Kit Server installed that is to be used for NXT machine, open
the Fuji Central Server Settings program by using the shortcut in the start up menu.
When selected the [Fuji Central Server Settings] dialog box is displayed.
2. Enter “FUJIADMIN” in the [User ID] text box and then enter the appropriate password
for this user ID.
3. Enter service name for the verifier database.
4. Specify the maximum desired log size for the Central Server from the [Log Size] drop-
down list.
5. Leave the default setting for [Miss Prevention Timer].