Need help?Do you have a question about the FujiFilm NXT and is the answer not in the manual?
General| Brand | FujiFilm |
|---|---|
| Model | NXT |
| Category | Industrial Equipment |
| Language | English |
Explains messages and symbols used in manuals and on machines.
Lists general safety rules applicable to all machine types.
Specific safety rules for the NXT main unit.
Safety precautions for operating and handling the Tray Unit-L.
Safety precautions for operating and handling the Tray Unit-M.
Explains the meaning of various safety labels found on NXT machines.
Step-by-step guide for safely locking out machine power and air.
Steps for safely unlocking the machine after maintenance.
Overview of the manual's purpose and setup procedures for the NXT machine.
Procedures and precautions for safely moving the NXT machine.
Detailed steps for transporting the machine, including leveling sheets.
Steps to remove red fixing brackets attached to the machine for transport.
Instructions for removing protective covers from M6S module linear motor shafts.
Connects the machine to the electrical power supply.
Connects the machine to the host computer via Ethernet.
Connects the machine to the external air supply hose.
Adjusts machine height and levelness to match panel conveyance height.
Configures IP address and network settings for the NXT base.
Describes how to connect independent NXT bases together.
Illustrates signal cable connections between NXT bases.
Shows different ways to extend the NXT configuration with additional bases.
Details types and quantities of pneumatic tubes for base connections.
Instructions for installing and fastening a single 2M base.
Configuration steps for using two 2M bases.
Configuration steps for using three 2M bases.
Configuration steps for using four 2M bases.
Configuration for two 2M bases and one independent 4M base (pattern 1).
Configuration for one 2M base and one independent 4M base (pattern 1).
Configuration for one 2M base and one independent 4M base (pattern 2).
Configuration for two 2M bases and one independent 4M base (pattern 2).
Configuration for one 4M base and one independent 4M base (pattern 1).
Configuration for one 4M base and one independent 4M base (pattern 2).
Instructions for connecting bases together for extensions.
Steps to connect NXT bases to preceding or succeeding machines.
Illustrates signal cable connections between NXT and other machine types.
Procedures to adjust the height and levelness of the Tray Unit-L.
Explains setting up NXT machines in Fuji Flexa for communication.
Steps to create a new factory in Fuji Flexa.
Steps to create a new line within a factory in Fuji Flexa.
Steps to add and configure an NXT machine in Fuji Flexa.
Overview of the Accessory Software and its requirements for NXT operation.
Outlines the major steps for installing the Accessory Software.
Specifies the hardware requirements for the Accessory Software server.
Introduces Fujitrax Verifier and its functions, and its connection to NXT.
Details on setting up and running the Fujitrax Verifier Central Server.
Steps to integrate NXT machines into the Fujitrax line configuration.
Guides on configuring NXT settings for Fujitrax Verifier.
Process for registering users for Kit Handy access to NXT information.
To Next Page