QD002-07 1. Safety Guideline
NXT Setup Manual 17
1.6 Locking System
When performing maintenance or service on the machine, all personnel who service the
machine should use locks to prevent others from turning on the machine power or air. This
procedure is referred to as a lockout.
To prevent accidents, especially those caused by mistakes when multiple operators are
present, all related personnel should have thorough knowledge of lockout procedures.
1.6.1 Lockout Procedure
Prepare 2 commercially available padlocks, and require all service personnel to carry
lockout nametags.
1. Switch off the machine power.
2. Rotate the main switch on the base to the OFF position.
3. Lock the main switch with a padlock.
All personnel working on the machine should attach their lockout nametags to the
padlock.
Note: Note:The presence of a nametag on the padlock signals that the machine is being serviced and that the
lock is not to be removed.
0
NXTSAF004
0
NXTSAF006
To Next Page
Loading...