QD002-07 6. Setting Up Fujitrax Verifier
NXT Setup Manual 149
15.Click [Add Base] from the [Edit] menu. The right pane changes to display the data fields
for the new base.
16.In the [Base Name] field, specify the name of the first NXT base for the machine.
17.Specify the base type using the [Base Type] drop-down list.
18.Click the new base in the left pane and the base name updates to display the specified
name.
19.Click [Add Module] from the [Edit] menu. The right pane changes to display the data
fields for the new module.
20.Specify the module type by using the [Module Type] drop-down list.
21.Click the new module in the left pane and the module name updates to display the
specified module type.
22.Repeat steps 19 to 21 until all of the modules for that base have been specified.
23.Click the base, and if the NXT machine is comprised of multiple bases, click [Add Base]
from the [Edit] menu. The right pane changes to display the data fields for the new base.
24.Repeat steps 14 to 23 until all bases for the NXT machine have been specified.
25.If there are any other NXT machines on the same line then select the new NXT machine
and repeat steps 7 to 24 until all NXT machines in the line have been specified.
26.If there are any other lines for this Kit Server with NXT machines, add the machines at
this time.
27.Select [Save] from the [File] menu and then [OK], and the file is saved to the database
and computers.
28.Select [Exit] from the [File] menu to quit Kit Line Configuration Editor.
To Next Page
Loading...