FujiFilm NXT - Page 6

Contents QD002-07
ii NXT Setup Manual
3.5.1 Procedure ............................................................. 36
3.6 Making Network Settings ............................... 39
3.6.1 Procedure ............................................................. 39
3.7 Connecting NXT Bases.................................. 40
3.7.1 Connecting Method............................................... 41
3.7.2 Signal Cable Connecting Diagram
(NXT - NXT - NXT)................................................ 43
3.8 Installing Additional Dependent Bases........... 44
3.8.1 Extension Patterns................................................ 44
3.8.2 Pneumatic Connections........................................ 45
3.8.3 Using One 2M Base.............................................. 46
3.8.4 Using Two 2M Bases............................................ 51
3.8.5 Using Three 2M Bases ......................................... 57
3.8.6 Using Four 2M Bases ........................................... 63
3.8.7 Using One 2M Base and an Independent
4M Base (1)............................................................ 68
3.8.8 Using Two 2M Bases and an Independent
4M Base (1)............................................................ 75
3.8.9 Using One 2M Base and an Independent
4M Base (2)............................................................ 84
3.8.10 Using Two 2M Bases and an Independent
4M Base (2)............................................................ 91
3.8.11 Using One 4M Base and an Independent
4M Base (1).......................................................... 100
3.8.12 Using One 4M Base and an Independent
4M Base (2).......................................................... 106
3.8.13 Fastening Extensions ....................................... 112
3.9 Connecting an NXT Base to Other Machine Types
....................................................................... 114
3.9.1 Procedure ........................................................... 115
3.9.2 Signal Cable Connecting Diagram
(Other machine type - NXT - Other machine type) 116
3.10 Tray Unit-L ................................................. 117
3.10.1 Adjusting the Height and the Levelness ........... 117
4. Setting Up NXT Machines in Flexa.................. 121
4.1 Introduction .................................................. 121
4.2 General Procedures..................................... 121