Chapter 1 System Management
1.9 Event/Dump Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
144
1.9 Event/Dump Management
This section describes event/dump management.
Event/dump management provides the following functions:
• Setup Event Notification
• Display/Delete Event Log
• Export/Delete Log
• Export/Delete Panic Dump
1.9.1 Setup Event Notification
This function specifies whether to report events that are detected in the ETERNUS DX.
There are six methods for event notification: Host Sense Key Code Qualifier, SNMP Trap, E-Mail, syslog, REMCS,
and AIS Connect.
A notification setting can be selected for each type of event.
For details on the parameters for this function, refer to "A.1.8.1 Setup Event Notification" (page 726)
.
For the factory default settings for this function, refer to "Appendix B Setup Event Notification" (page 983)
.
The procedure to set the event notification is as follows:
1 Click [Setup Event Notification] in [Action].
• For SNMP Trap notification, performing procedures in the following sections is required.
- "1.8.3 Setup SNMP Agent Basic Interface" (page 111)
- "1.8.4 Setup SNMP Manager" (page 113)
- "1.8.5 Setup SNMP Agent MIB Access View" (page 115)
- "1.8.6 Setup SNMP Agent User" (page 117)
- "1.8.7 Setup SNMP Agent Community" (page 120)
- "1.8.8 Setup SNMP Agent Trap" (page 123)
• For E-Mail notification, performing procedure in "1.8.12 Setup E-Mail Notification" (page 130) is required.
• For syslog notification, performing procedure in "1.8.13 Setup Syslog" (page 132)
is required.
• For REMCS notification, performing procedure in "1.13.2 Setup Remote Support" (page 193)
is required.
• For AIS Connect notification, performing procedure in "1.14.1 Setup AIS Connect Environment" (page 206)
is required.
When selecting REMCS for event notification, only the REC related error event settings can be changed.
To Next Page
Loading...
Need help?
General