Appendix A Parameter List
A.7 Advanced Copy Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
942
A.7.5 Set Copy Path
For details about this function, refer to "7.8.2 Set Copy Path" (page 612).
For the factory default settings for this function, refer to "Appendix B Set Copy Path" (page 1010)
.
● Operation Mode Selection
• Operation Mode
● Base Information Selection
• Base Information
● Copy Path Information File Selection
• Copy path information file
● Registered Storage System List
• Checkboxes for selecting a storage system
Description Select the operation mode.
Input condition/
Display contents
• Create Copy Path
Create a copy path and apply to the ETERNUS DX.
• Apply Copy Path
Apply the existing copy path information file to the ETERNUS DX.
Description Specify the registration method for storage system information.
Input condition/
Display contents
• Backup Path File
The copy path information file previously applied is used.
• Path File
The copy path information file stored in the setting PC is used.
• Not use
Copy path is newly created.
Description Input the location where the copy path information file is stored.
Click the [Browse...] button to specify the location, or input the location directly.
Input condition/
Display contents
• Click the [Browse...] button to specify the location
• Directly input the location
Description A list of the storage system information specified in the copy path information file
previously applied or stored in the ETERNUS DX is displayed.
Select the ETERNUS Disk storage system to create a copy path.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
To Next Page
Loading...
Need help?
General