Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
454
4.3.9 Modify SAS Port Parameters
This function sets the parameters for the SAS host interface port that connects between the ETERNUS DX and
the host.
For details on the parameters for this function, refer to "A.4.3.8 Modify SAS Port Parameters" (page 864)
.
For the factory default settings for this function, refer to "Appendix B Modify SAS Port Parameters" (page 998)
.
The procedure to set SAS port parameters is as follows:
1 Select the SAS port to set the parameters for (multiple selections can be made) and click
[Configure SAS Port] in [Action].
2 Set the parameters for all of the selected ports.
• The ETERNUS DX500 S3/DX600 S3, the ETERNUS DX8700 S3/DX8900 S3, and the ETERNUS DX200F do not
support this function.
• When changing port parameters during operation, stop access from the server that is allocated to the
target port. Host access does not need to be stopped to change the port parameters of newly added CA
ports.
For more details on SAS parameter settings, refer to "FUJITSU Storage ETERNUS DX Configuration Guide
-Server Connection-" for each OS type.
Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port. After
the specification is complete, click the [Modify] button.
To Next Page
Loading...
Need help?
General