Chapter 1 System Management
1.10 Audit Log Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
162
1.10 Audit Log Management
This section describes audit log management.
The following functions are available with Audit log management:
• Enable Audit Log
• Disable Audit Log
• Setup Audit Log
1.10.1 Enable Audit Log
This function enables the audit log function.
For the factory default settings for this function, refer to "Appendix B Audit Log" (page 983)
.
The procedure to enable the audit log function is as follows:
1 Click [Enable Audit Log] in [Action].
A confirmation screen appears.
• Enable the "Audit Log" setting, and then specify the destination external server. Refer to "1.10.3 Setup
Audit Log" (page 164) for details. Audit logs are sent after the external server is specified.
• Note that the ETERNUS DX does not save the audit log. The audit log is only sent to the specified external
server.
The conditions for collecting audit logs are as follows:
• The interface must be ETERNUS Web GUI, ETERNUS CLI, or software that accesses the ETERNUS DX via
ETERNUS CLI or SMI-S
• The user who logs in or is newly logged in when the external server is set after the "Audit Log" is enabled
• Audit log collection target operations (*1)
*1: Refer to "Audit Log" in "ETERNUS Web GUI User’s Guide (Operation)" for details about log collection target
operations.
If the audit log function has already been enabled, [Enable Audit Log] cannot be clicked.
To Next Page
Loading...
Need help?
General