Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 1 Outline
1.3 Notes for Using GUI
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
14
1.3 Notes for Using GUI
Note the following points when using GUI:
• If the PC and the ETERNUS DX belong to a different network and the transfer rate setting for each network
does not match, the retransmission of packets occurs more frequently and the operation screen for GUI
may take more time to display.
By setting the same transfer rate for each network (adjusted to the lowest of the transfer rates), the
retransmission of packets can be reduced. Note the following points when setting the transfer rate:
- Set the same transfer rate for each network
- When the transfer rate for the ETERNUS DX is not "Auto-negotiation", the same transfer rate must also
be set for the network switches
• Do not use the standard buttons of each browser (for example, the [Back] button, the [Forward] button,
and the [Refresh] button), the [F5] (refresh) key, or the [Back Space] (back) key.

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted