EasyManuals Logo

Fujitsu ETERNUS DX200 S3 Setup Guide

Fujitsu ETERNUS DX200 S3
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Chapter 5 Host Interface Management
5.2 Modify Port Parameters
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
76
5.2.2 Modify iSCSI Port Parameters
This function sets the parameters for the iSCSI host interface port that connects between the ETERNUS DX and
the host, or connects between the storage systems for REC.
The procedure to set iSCSI port parameters is as follows:
Procedure
1 Select which iSCSI port to set the parameters for (multiple selections can be made) and click
[Configure iSCSI Port] in [Action].
The [Modify iSCSI Port Parameters] screen appears.
When changing port parameters during operation, stop access from the server that is allocated to the target
port. Host access does not need to be stopped to change the port parameters of newly added CA ports.
Multiple "1G iSCSI" or "10G iSCSI" type iSCSI ports with the same port mode can be selected.
Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.

Table of Contents

Other manuals for Fujitsu ETERNUS DX200 S3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu ETERNUS DX200 S3 and is the answer not in the manual?

Fujitsu ETERNUS DX200 S3 Specifications

General IconGeneral
ModelETERNUS DX200 S3
CategoryStorage
Number of Controllers2
Drive Types SupportedSAS, Nearline SAS
RAID Levels0, 1, 5, 6
Power SupplyRedundant
Management SoftwareETERNUS SF
Host InterfacesFibre Channel, iSCSI, SAS
Form FactorRack-mounted

Related product manuals