EasyManuals Logo

Fujitsu ETERNUS DX200 S3 Setup Guide

Fujitsu ETERNUS DX200 S3
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning
4.4 When Using Thin Provisioning Volumes (TPVs)
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
54
4.4 When Using Thin Provisioning Volumes (TPVs)
The following section shows the series of settings that need to be performed to use Thin Provisioning Pool Vol-
umes.
Not only can new Thin Provisioning Pool be created, adding or changing volumes that are registered in the
existing Thin Provisioning Pools can also be performed.
Set Thin Provisioning
Enable the Thin Provisioning function.
Refer to:
-
Set Thin Provisioning
Create Thin Provisioning Pool
Create a Thin Provisioning Pool (groups of drives (which are configured in RAID groups) that
configure a Thin Provisioning Pool).
Refer to:
-
Create Thin Provisioning Pool
Create Volume
Create a volume (physical drive area in the Thin Provisioning Pool). A volume is a structural unit
of a Thin Provisioning Pool that can be recognized from the server. Select "Thin Provisioning" for
"Type".
Refer to:
-
Create Volume

Table of Contents

Other manuals for Fujitsu ETERNUS DX200 S3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu ETERNUS DX200 S3 and is the answer not in the manual?

Fujitsu ETERNUS DX200 S3 Specifications

General IconGeneral
ModelETERNUS DX200 S3
CategoryStorage
Number of Controllers2
Drive Types SupportedSAS, Nearline SAS
RAID Levels0, 1, 5, 6
Power SupplyRedundant
Management SoftwareETERNUS SF
Host InterfacesFibre Channel, iSCSI, SAS
Form FactorRack-mounted

Related product manuals