Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning
4.3 When Using SnapOPC+ (SDVs and SDPVs)
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
53
4.3 When Using SnapOPC+ (SDVs and SDPVs)
The following section describes the series of environment settings when using SnapOPC+ (SDVs and SDPVs).
Not only can new RAID groups be created, adding or changing volumes that are registered in existing RAID
groups can also be performed.
Create RAID Group
Create a RAID group (a group of drives that configures the RAID in the ETERNUS DX).
Refer to:
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system
Configuration Guide (Basic)"
- "RAID Group Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system
Configuration Guide (Basic)"
- "RAID Group Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configuration
Guide (Basic)"
Create Volume
Create a volume (drive area in the RAID group). A volume is a structural unit of RAID that can be
recognized from the server. Select "SDV" or "SDPV" for "Type".
Refer to:
-
"Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration
Guide (Basic)"
- "Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration
Guide (Basic)"
- "Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)"

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted