Chapter 5 Host Interface Management
5.4 Set Host Response
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
89
5.4 Set Host Response
The host response configures the appropriate operation mode on which the host makes connection. In normal
host connection, the recommended patterns prepared for each OS type in advance or the default settings are
used.
Recommended Patterns of Host Responses
For details about the recommended patterns of host responses, refer to "Add Host Response" in "ETERNUS Web
GUI User’s Guide (Settings)".
For details on assigning an appropriate host response, refer to "FUJITSU Storage ETERNUS DX Configuration
Guide -Server Connection-". For details on modifying the host response settings, refer to "Add Host Response"
in "ETERNUS Web GUI User's Guide (Settings)".
Host response name Connection environment
Solaris MPxIO Set this parameter to connect to an Oracle Solaris host and to use the OS standard Multipath
Driver (MPxIO).
HP-UX Set this parameter to connect to an HP-UX host.
AIX Set this parameter to connect to an AIX host.
AIX VxVM Set this parameter to connect to an AIX host and to use VERITAS Volume Manager (VxVM).
VS850/SVC Set this parameter to connect to an ETERNUS VS850 Virtualization Storage or an IBM SAN
Volume Controller (SVC).
BS2000 Set this parameter to connect to a BS2000 host and to enable the LUN expand mode.
Default Set this parameter for any host connection environments that are not listed above.
To Next Page
Loading...
Need help?
General
