Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 3 Initial Setup
3.1 Initial Setup 1
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
28
3 Proceed to [Set Storage System Name].
3-1 Specify the parameters.
The main setting items are as follows.
- Name (Required)
- Installation Location
- Administrator
- Description
3-2 Click the [Next >>] button
 A confirmation screen appears.
3-3 Click the [OK] button.
 Setting of the storage system name starts.
3-4 Click the [Done] button.
If not logging in for the first time, click the [Skip] button to proceed to the next screen without
setting.

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted