Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 3 Initial Setup
3.1 Initial Setup 1
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
34
9 Click the [Close] button.
 The browser is closed, and Initial Setup 1 is complete.
End of procedure
• Follow the on-screen instructions to reboot the ETERNUS DX if needed.
• Restart the browser, and wait a few minutes before logging into the GUI again. After logging in
again, continue with the initial setup. Proceed to Initial Setup 2.

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted