Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 3 Initial Setup
3.2 Initial Setup 2
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
36
The procedure to perform Initial Setup 2 is as follows:
Procedure
1 Click [Initial Setup] in [Action].
2 Click the [Next >>] button.
 Initial Setup restarts.
• When logging in again after Initial Setup 1 is complete, the [Initial Setup 2] screen appears.
• If all of the settings of Initial Setup 2 are not performed, click the [All Skip] button to exit the Initial
Setup wizard.

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted