The LEDs turn on or blink to indicate the statuses that are listed below.
Table 3 Status and Meanings of Each LED (Controller)
LED name LED status Meaning
IDENTIFY/BBU FAULT
(blinks blue)
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
location of the controller is identified.
(amber)
The battery is in error status.
DI (OUT) LINK/FAULT
(green)
The link between the DI (OUT) port and the destination port has
been established.
(amber)
•
The link between the DI (OUT) port and the destination port is
in error status.
•
The ports to remove the cables between enclosures from are in-
dicated. This occurs while a drive enclosure is being added.
(blinks amber)
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
LAN ACT
(blinks green)
Data is being sent or received via the LAN port.
LAN LINK
(green)
The link between the LAN port and the destination has been es-
tablished.
READY/FAULT
(green)
The controller is in normal status.
(blinks green)
An error has occurred during startup.
(amber)
•
The controller is performing the initial setup after the power is
turned on.
•
The controller is in error status.
(blinks amber)
LINK/FAULT
(green)
The link between the host interface port (FC or SAS) and the des-
tination port has been established.
(amber)
The host interface port (FC or SAS) is in error status.
FAULT
(green)
The link between the host interface port (iSCSI) and the destina-
tion port has been established.
LINK
(amber)
The host interface port (iSCSI) is in error status.
CA FAULT
(amber)
The host interface is in error status.
MASTER
(green)
The controller is set as a Master CM.
1. Component Names and LED Names
Controller Enclosures
16
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0
To Next Page
Loading...
