Fujitsu ETERNUS DX60 S3 - 3 Storage System Monitoring; Checking LED Status; Displaying Status Via ETERNUS Web GUI; Figure 40 ETERNUS Web GUI Screen

3. Storage System Monitoring
This chapter describes the status monitoring of the ETERNUS DX.
Checking LED Status
The status of the ETERNUS DX can be checked by the LEDs.
If the FAULT LED in the operation panel is amber, contact your maintenance engineer.
Displaying Status via ETERNUS Web GUI
The status of the ETERNUS DX and the usage status of RAID groups, TPPs, and SDPs can be checked in the Over-
view screen of ETERNUS Web GUI.
Figure 40 ETERNUS Web GUI Screen
Table 11 shows the general status.
Status of the ETERNUS DX is monitored periodically, and the result is displayed as a general status icon with
character strings.
Table 11 General Status of ETERNUS Web GUI
Status
Description
(green)
The ETERNUS DX is in a normal state.
(red)
An abnormality is detected at a power-off, and I/O access from the server
cannot be received.
43
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0