Fujitsu ETERNUS DX60 S3 - Installing Additional Drive Enclosures; Installable Drive Enclosures; Drive Enclosure Handling Instructions

Installing Additional Drive Enclosures
Drive enclosures can be installed while the ETERNUS DX is running without affecting the system.
This section explains how to install drive enclosures in the ETERNUS DX.
Do Not
•
Do not uninstall or move a drive enclosure that is already installed.
Contact your sales representative or maintenance engineer if a drive enclosure needs
to be uninstalled or moved.
Do
•
When installing the ETERNUS DX, secure the rack to the floor to prevent the rack from
moving out of place or from toppling over. For details on the rack installation require-
ments, refer to "Site Planning Guide".
Installable Drive Enclosures
For installable drive enclosures, refer to "Product List".
Drive Enclosure Handling Instructions
■
About Condensation
Do
•
When moving a drive enclosure from a cold place, such as an unconditioned store
house in winter, to a warmer place such as an air-conditioned room, the severe tem-
perature change may result in condensation forming.
To avoid this, allow the packed drive enclosure sufficient time in the warmer place
(one hour for each 15°C of temperature difference) to adapt to the new temperature.
4.
Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
54
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0