Fujitsu ETERNUS DX60 S3 - Powering off

1 Press the Power switch of the controller enclosure.
Power switch
The POWER LED is turned on.
2 After approximately five minutes, check that the READY LED is lit up.
Powering Off
This section explains how to turn off the ETERNUS DX.
To turn off the ETERNUS DX, perform one of the procedures below.
•
Via power switch
Press the Power switch to turn off the ETERNUS DX.
•
Via ETERNUS Web GUI or ETERNUS CLI
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS DX.
The following methods can be used to turn off the power by linking with the server.
•
Via the power synchronized unit
Use the power synchronized unit to turn off the ETERNUS DX.
2.
Basic Operation
Powering On and Off
39
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0