Status Description
(red)
The ETERNUS DX is in error state.
(orange)
The ETERNUS DX is under maintenance.
(yellow)
The ETERNUS DX is in warning state.
For details, refer to "Configuration Guide (Web GUI)".
Displaying Status via ETERNUS CLI
The status of the ETERNUS DX and the usage status of RAID groups, TPPs, and SDPs can be checked by sending
the status display command via ETERNUS CLI.
CLI> show status
Summary Status [Normal]
CLI> show status
Summary Status [Error]
CLI> show status
Summary Status [Warning]
The general status of the ETERNUS DX indicates whether an error status component or a warning status compo-
nent exists in the storage system.
Table 12 General Status of ETERNUS CLI
Status
Description
Empty An undefined or uninstalled component exists in the ETERNUS DX.
Normal The ETERNUS DX is in a normal state.
Pinned Data Pinned data exists in the ETERNUS DX.
Unused An undefined component is installed in the ETERNUS DX.
Warning The ETERNUS DX contains a component that requires preventive maintenance.
Maintenance The ETERNUS DX is under maintenance.
Error An error has occurred in a component that is installed in the ETERNUS DX.
Loop Down The ETERNUS DX is in the BackEnd Down state.
Not Ready An abnormality is detected and access from the host cannot be received.
Subsystem Down The ETERNUS DX cannot be used.
Change Assigned CM CM hot expansion recovery is required.
Event Notification
By setting event notification, if an error (event) occurs in the ETERNUS DX, the event information is notified.
The methods that can be used to notify an event are "e-mail", "SNMP Trap", "Syslog", "remote support", and "host
sense".
For the procedure on setting event notification, refer to "Configuration Guide (Basic)".
3.
Storage System Monitoring
Displaying Status via ETERNUS CLI
44
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0
To Next Page
Loading...
