Fujitsu ETERNUS DX60 S3 - Components (Rear); Figure 23 I;O Module; Table 8 Status and Meanings of each LED (Drive (Drive Enclosure)); Table 9 Status and Meanings of each LED (I;O Module)

The LEDs turn on or blink to indicate the statuses that are listed below.
Table 8 Status and Meanings of Each LED (Drive (Drive Enclosure))
LED name LED status Meanings
DRIVE READY
(green)
The drive is in normal status.
(blinks green)
DRIVE FAULT
(amber)
•
The drive is in error status.
•
The LED light up operation was performed from the ETERNUS
CLI command line in order to identify the drive location.
Components (Rear)
This section describes the I/O modules and the power supply units in the rear of the drive enclosure.
■
I/O Modules
The I/O module is a component that controls how the controller and the drives interact.
Figure 23 shows the I/O module. Table 9 shows the status and meanings of each LED.
Figure 23 I/O Module
14
7
8
9
23 56
1.
DI (IN) port
This port is used to connect between enclosures.
2. DI (IN) LINK LED
3. DI (IN) FAULT LED
4. DI (OUT) port
This port is used to connect between enclosures.
5. DI (OUT) LINK LED
6. DI (OUT) FAULT LED
7. READY LED
8. IDENTIFY LED
9. FAULT LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 9 Status and Meanings of Each LED (I/O Module)
LED name
LED status Meaning
DI (IN) LINK
(green)
The link between the DI (IN) port and the source port has been
established.
1. Component Names and LED Names
Drive Enclosures
26
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0