Fujitsu ETERNUS DX60 S3 - 1 Component Names and LED Names; Controller Enclosures; Front; Figure 1 Front View of a 2.5 Type Controller Enclosure

1. Component Names and LED Names
This chapter provides the component names of the ETERNUS DX.
Controller Enclosures
An operation panel and drives are installed in the front of the controller enclosure. Controllers and power supply
units are installed in the rear.
Note that some LED names of the controllers are different in the ETERNUS DX60 S4 and the ETERNUS DX60 S3.
Front
This section provides the names of the components on the front of a controller enclosure.
■
2.5" Type
Figure 1 Front View of a 2.5" Type Controller Enclosure
1
3 3
2
1.
Operation panel
2. 2.5" drive
3. Flange cover
■
3.5" Type
Figure 2 Front View of a 3.5" Type Controller Enclosure
1
3 3
2
1.
Operation panel
2. 3.5" drive
3. Flange cover
9
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0