EasyManua.ls Logo

Fujitsu ETERNUS DX60 S3 - Table 5 Status and Meanings of each LED (Controller)

Fujitsu ETERNUS DX60 S3
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10. Host interface port (SAS port) (CA#0, Port#0)
This port is used for connecting an SAS cable. This port uses a miniSAS (SFF-8088) connector.
11. Host interface port (SAS port) (CA#0, Port#1)
This port is used for connecting an SAS cable. This port uses a miniSAS (SFF-8088) connector.
12. IDENTIFY/SCU READY LED
13. DI (OUT) LINK/FAULT LED
14. LAN ACT LED
15. LAN LINK LED
16. READY/FAULT LED
17. LINK/FAULT LED
18. FAULT LED
19. LINK LED
20. CA#0 FAULT LED
21. MASTER LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 5 Status and Meanings of Each LED (Controller)
LED name
LED status Meaning
IDENTIFY/SCU READY
(blinks blue)
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
location of the controller is identified.
(blinks green)
System Capacitor Unit (SCU) is charging.
DI (OUT) LINK/FAULT
(green)
The link between the DI (OUT) port and the destination port has
been established.
(amber)
The link between the DI (OUT) port and the destination port is
in error status.
The ports to remove the mini SAS HD cables between enclo-
sures from are indicated. This occurs while a drive enclosure is
being added.
(blinks amber)
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
LAN ACT
(blinks green)
Data is being sent or received via the LAN port.
LAN LINK
(green)
The link between the LAN port and the destination has been es-
tablished.
READY/FAULT
(green)
The controller is in normal status.
(blinks green)
An error has occurred during startup.
(amber)
The controller is performing the initial setup after the power is
turned on.
The controller is in error status.
(blinks amber)
LINK/FAULT
(green)
The link between the host interface port (FC or SAS) and the des-
tination port has been established.
(amber)
The host interface port (FC or SAS) is in error status.
1. Component Names and LED Names
Controller Enclosures
19
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-9012-08ENZ0

Table of Contents

Other manuals for Fujitsu ETERNUS DX60 S3

Related product manuals