EasyManua.ls Logo

Fujitsu ETERNUS LT20 S2 - 10 Regulatory Information; Device Standards; FCC (United States)

Fujitsu ETERNUS LT20 S2
118 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ETERNUS LT20 S2 113
10 Regulatory Information
This chapter describes the tape library compliance with safety and regulatory
agency standards.
10.1 Device Standards
IEC 60297 Rack Standards
10.2 FCC (United States)
The computer equipment described in this manual generates and uses radio
frequency (RF) energy. If the equipment is not installed and operated in strict
accordance with the manufacturer's instructions, interference to radio and
television reception might result.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Part 15, Class A, of the FCC Rules, is designed to provide reasonable
protection against radio and television interference in a residential installation.
Although the equipment has been tested and found to comply with the allowed
RF emission limits, as specified in the above cited Rules, there is no guarantee
that interference will not occur in a particular installation. Interference can be
Countries Standard
(Fujitsu)
European Union
USA/Canada
Germany
CE
FCC, ETL, ICES-003, Class A
GS Semco

Table of Contents

Other manuals for Fujitsu ETERNUS LT20 S2

Related product manuals