Fujitsu ETERNUS LT20 S2 - Rack Mounting the Tape Library

ETERNUS LT20 S2 21
Installing the Tape Library Rack Mounting the Tape Library
The shipping lock is held in place with a label and is located in the top center of
the library. After the shipping lock is removed, it should be stored on the rear
panel right side (next to power connector) of the library for future use.
To remove and store the shipping lock:
1. Remove the yellow label that is securing the lock to the top of the library, and
then remove the lock (see figure 8).
Figure 8: Removing shipping lock and label
2. Replace the label on top of the library and store the shipping lock next to
power supply (see figure 9).
Figure 9: Storing shipping lock and label
I If you need to transport the library, it is recommended that the
shipping lock and label is replaced on the top cover (see chapter
“Packaging before Transportation” on page 105).
3.5 Rack Mounting the Tape Library
V WARNING
Weight!
Risk of personal injury or damage to the loader.
● Always remove all tapes to reduce the overall weight of the loader.
● Observe local health and safety requirements and guidelines for
manual material handling.