Fujitsu ETERNUS LT20 S2 - Removing Stuck Tapes from Slots

88 ETERNUS LT20 S2
Removing Stuck Tapes from Slots Troubleshooting
5.3 Removing Stuck Tapes from Slots
1. Unlock the magazine and remove it from the library:
Ê use the OCP, see section “Removing and Replacing a Magazine Using
the OCP” on page 46, or
Ê use the RMU, see section “Removing and Replacing a Magazine Using
the RMU” on page 47.
2. The finger holes on the back side of the magazines (see figure 68) allow the
user to pull the cartridges out of the slot. Remove and insert the cartridge
mechanically. Repeat the process ten times.
Figure 68: Removing stuck tapes from slot
3. During this process any burr on the cartridges will be removed.
4. Insert cartridge in the magazine.
5. Put the magazine back to the tape library.