ETERNUS LT20 S2 93
Troubleshooting Tape Library Error Codes
5.6.2 Error Code Table
Error Code Description User Action
80 Barcode Reader Error, cannot
initialize BCR
Retry operation; after several
occurrences contact
technical support
81 Barcode Reader Error, no
response from BCR
Retry operation; after several
occurrences contact
technical support
82 EEPROM Error, no response
from EEPROM (located on robot
controller)
Retry operation; after several
occurrences contact
technical support
83 Robot controller generic problem Reset the unit and retry
operation. After several
occurrences contact
technical support
84 Setting of gripper motor param-
eters failed
Reset the unit and retry
operation. After several
occurrences contact
technical support
85 Setting of slider motor param-
eters failed
Reset the unit and retry
operation. After several
occurrences contact
technical support
86 Setting of elevator motor param-
eters failed
Reset the unit and retry
operation. After several
occurrences contact
technical support
87 Setting of rotation motor param-
eters failed
Reset the unit and retry
operation. After several
occurrences contact
technical support
88 Setting of sled motor parameters
failed
Reset the unit and retry
operation. After several
occurrences contact
technical support
To Next Page
Loading...
