Fujitsu ETERNUS LT20 S2 - Changing the System Configuration; Configuration

58 ETERNUS LT20 S2
Remote Management Unit (RMU) Operating the LTO Library
4.4.6 Configuration
4.4.6.1 Changing the System Configuration
As changes are made, they will only be applied after the "Apply Selections" (or
"Submit") button down right is selected. To make the changes visible, you have
to click the "Refresh" button. After making the selection, a warning page will
inform the user of the impact of their proposed change. In some cases a pop-
up screen will ask the operator to confirm their change. Many changes will also
require a reboot. You can reach this page by selecting Configuration → System.
Changes that can be made are:
–Library Master Drive
– Library Mode: Random, Sequential, Automatic, Auto load, Loop
– Active Slots
– Mailslot Enabled
– Auto Clean Enabled
– Barcode Label Length Reported To Host
– Barcode Label Alignment Reported To Host
– Select Language
– Change ID String
Figure 39: Configuration, System page
I Using the Select Language function changes both the language of the
graphical user interface of the RMU and the embedded help manual.