Fujitsu LIFEBOOK E Series

Copyright
v
AUSTRALIAN
WARNINGS
WARNING
FOR SAFETY REASONS, ONLY CONNECT
EQUIPMENT WITH A
TELECOMMUNICATIONS COMPLIANCE
LABEL. THIS INCLUDES CUSTOMER
EQUIPMENT PREVIOUSLY LABELLED
PERMITTED OR CERTIFIED.
Connection of Non Certified/Approved
peripherals may result in the equipment
operating outside the Australian EMI
Standards.
Modems connected to the Australian
telecommunications network must be operated
in accordance with the Labelling Notice. This
modem has been specifically configured to
ensure compliance with the ACA Standards.
Do not adjust your modem or software outside
the values indicated below. To do so would
result in your modem being operated in a non-
compliant manner.
Call Attempts/Retries:
Applications software shall be configured so
that no more than 3 attempts are made to
establish a connection to a given number
(Note: if the modem can detect service tones,
up to 10 attempts can be made). If the call
sequence is unsuccessful, there shall be a
delay of at least 30 minutes before attempting
to call the number again.
Failure to set the modem, and any application
software used with the modem, to the values
shown above will result in the modem being
operated in a non-compliant manner.
Consequently, this would be in violation of the
Labelling Notice for this equipment, and the
Telecommunications Act 1997 prescribes
penalties for the connection of non-compliant
equipment.
LB_Railto 01 (Intro) 17/4/03, 6:17 PM5