LifeBook E Series - Section 4
48
Stopping the transmission of
radio waves
To use this product in hospitals, clinics, or
airplanes, or in other places where the use of
electronic equipment is regulated, stop the trans-
mission of radio waves from the wireless LAN.
Deactivation using the wireless
switch
The transmission of radio waves from the wire-
less LAN can be stopped by setting the wireless
switch to the OFF position.
For the wireless switch, refer to the Names of
components” section of the relevant manual ac-
companying the main unit of the personal com-
puter.
Deactivation using your Windows
1. Click the [Start] button, [All Programs],
[Intel Network Adapters], and [Intel(R)
PROSet].
The Intel(R) PROSet window will be dis-
played.
2. Click the [Genaral] tab.
3. Select [OFF] for the wireless communi-
cations on/off switching function, and
then click the [OK] button.
Wireless communications on/off switching
will be deactivated and the transmission of
radio waves from the wireless LAN will be
stopped.
Select [ON] under the deactivated status
of the wireless LAN to restart the trans-
mission of radio waves.
Starting the transmission of
radio waves
To communicate using the wireless LAN func-
tion, set the personal computer to a status in
which it can transmit radio waves. Here is the
procedure:
1. Set the wireless switch to the ON posi-
tion.
For the wireless switch, refer to the “NAMES
OF COMPONENTS” section of the relevant
manual accompanying the main unit of the
personal computer.
2. Click the [Start] button, [ All Programs],
[Intel Network Adapters], and [Intel(R)
PROSet], in that order.
The Intel(R) PROSet window will be dis-
played.
3. Click the [General] tab.
4. Select [ON] for the wireless communica-
tions on/off switching function, and then
click the [OK] button.
Wireless communications on/off switching
will be activated and the transmission of ra-
dio waves will be restarted.
LB_Railto 08 (39-48) 21/5/03, 2:11 PM48
To Next Page
Loading...
