Working w ith the notebook
Removing the card
Always remove the card according to the rules described below, to
ensure that none of your data is lost.
You can stop the card using the corresponding icon in the task bar:
► Left click on the icon to safely remove hardware, located in the taskbar.
► Select the card you wa nt to stop
and remove.
► Press the "Enter" key.
Wait for the dialog box which tel
ls you that it is now safe to remove the card.
1
2
► If the eject button is lowere d, you must
first cause the eject button to r elease
from the notebook casing. To do this,
press the eject button until it pops out.
Press the eject button (1) so that the card
protrudes a little from the notebook.
► Pull the card out of the slot (
2).
► Insert the card placeholder into the
slot guide.
► Care fully slide the placeholder for the
card as far as it w ill go into the slot.
Do not use e xcessive force.
Loudspeakers and microphones
Microph
one
Loudspe
akers
Basslou
dspeaker (subwoofer)
Volum ec
ontrol
Information on the exact po sition of the speakers and microphone can be found
in "
Ports and operating elem ents", Page 9.
Please refer to chapter "
Key combinations", Page 24 for information on setting the volume
and also enabling/disabling the loudspeakers using key combinations.
If you attach an external microph one, the built-in microphone is disabled.
When you connect headphones or external speakers, the built-in speakers are disabled.
Information on connecting headphones and a microphone can be found
in "
Connecting exter nal devices", Page 64.
44 Fujitsu Technology S olutions
To Next Page
Loading...
