Working w ith the notebook
Connecting the mains a dapter to the Port Replicator
1
2
3
► Connect the mains adapter cable to the DC
jack (DC IN) of the Po rt Replicator (1).
► Connect the power cable to the
mains a d apter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mo de. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port Rep licator of the same type.
Switching on the notebook via the port replicator
► Press the O N/O FF
switch on the port
replicator to sw
itch the notebook on.
The power-on indicator of the Port
Replicator lights up .
Switching
off notebook via Port Replicator
► Close all applications and shut dow n y our operating system (please refer
to the manual for the operating system).
If the notebook cannot be shut down prop erly, press the ON/OFF button
on the Port R eplicator for approx. four seconds. The notebook w ill switch
off. Any unsaved data may however be lost.
52 Fujitsu Technology S olutions
To Next Page
Loading...
