Removing and installing compone nts
during servicing
Attaching the cover
2
1
► Place the cover in the correct mounting position (1).
If you remove more than one component at th e same time, keep the screws for the
individual componen ts separately from each other and make sure that you use the
correct screws. If you install the wrong screws, compon ents may be damaged.
► Tighten the screw (2).
► Insert the battery (see Chapter "
Installing a battery", Page 34).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare your device for operation again as follows:
► Install the batte ry again (see "
Installing a battery", Page 34 ).
► Turn the notebook the right way up again and place it on a flat surface.
► Reconnect the cables that you disconnected before.
Fujitsu Technology Solutions 77
To Next Page
Loading...
