Working w ith the notebook
Wireless LAN/ Bluetooth (device-dependent)
/ UMTS (device-dependent)
The installation of a radio components not approved by F ujitsu Technology
Solutions will invalidate the certifications issued for this device.
Switching the wireless components on and off
Before switching on your device for the first time, the on/off switch for
radio components must be in the "ON" position.
► Slide the ON/OF F switch into the "ON"
position to activa te the radio components.
Wireless LANWirelessLANBluetoothBluetooth
or
► Slide the ON/OFF switch to the
"OFF" position to deactivate the
radio components.
If you switch off
the radio components, the wireless LAN transmission unit (antenna)
and, if present
, the Bluetooth an d UMT S module will also be switched off.
You can enable an
d disable the installed radio components individually
using the Wirel
essSelector programme
You can also dea
ctivate the wireless components individually in the BIOS Setup.
For this to occu
r, you must either not have assigned a sup ervisor password or if a
supervisor pa
ssword has been assigned, you must know this password.
Pay attention t
o the additional safety notes for devices with wireless
components pr
ovided in the "Safety" manual.
Details on usin
g Wireless LAN can be found in the online help system
included in th
e Wireless LAN software.
You can find mor
e information on how to use B luetooth on the CD you
received with
your Bluetooth software.
You can obtain
more information on UMTS from your service provider.
48 Fujitsu Technology S olutions
To Next Page
Loading...
