U41221-J-Z156-1-74 53
Plug-in Board Modules The FFx-RAID Controller Module
I Refer also to the MultiPath software requirements for the FFx-RAID
controller settings, e. g.: both controller must be configured identically.
In a single-mode configuration (with only one module installed), the storage
subsystem must be turned OFF before removing the module.
Ê Remove all connection cables from the FFx-RAID controller module
connectors.
Figure 21: Loosening the Knurled Screw
Ê Loosen the knurled screw on the FFx-RAID controller module.
To Next Page
Loading...
