EasyManuals Logo

Fujitsu PRIMERGY S60 User Manual

Fujitsu PRIMERGY S60
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
76 U41221-J-Z156-1-74
Problem Solutions and Tips Troubleshooting
11.1.7 Hard Disk Drives“ dead” on System Start
Configuration of the FFx-RAID controller incorrect
Ê Correct the settings for the hard disk drives.
You will find further notes in the documentation of the configuration software.
11.1.8 Controller reports Added Hard Disk Drive as
defective
This error message can have the following cause:
FFx-RAID controller not configured for the hard disk drive
The HDD module was installed with the system switched OFF.
Ê Configure the FFx-RAID controller retroactively for the drive.
or
Ê Re-install the HDD module with the system switched ON.
If the hard disk drive is still reported as defective, the HDD module must be
replaced (see section “Hot Swap for FC HDD Modules” on page 42).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY S60 and is the answer not in the manual?

Fujitsu PRIMERGY S60 Specifications

General IconGeneral
BrandFujitsu
ModelPRIMERGY S60
CategoryServer
LanguageEnglish

Related product manuals