Maintaining Units Special Maintenance Instructions
Page 64 MDE-3893P Encore® and Eclipse® Series Owner’s Manual · December 2011
Deep Cleaning and Detailing
Perform the following deep cleaning and detailing as required - at least once a year. This helps
restore the original color to the painted surfaces.
1 Perform steps 1 to 8 on page 63 of the Routine Cleaning procedure except, in step 3 on
page 63, prepare a mixture of one (1) part Concentrated Simple Green cleaner to one (1) part
water.
2 Using a new clean white cloth, apply the Nu Finish polish to the cloth and apply the polish to
the painted or metal surfaces of the unit.
Note: For difficult-to-remove ground-in dirt, apply Nu Finish polish to the soft bristle nylon
brush and rub the surface.
3 Wipe surface of the unit with a clean white cloth.
4 Remove barricade(s) and cleaning supplies from the unit area.
• Do not apply the Nu Finish polish to textured surfaces.
• Do not apply the Nu Finish polish to electronic displays or nozzle boots.
IMPORTANT INFORMATION
To Next Page
Loading...
