MDE-3893P Encore® and Eclipse® Series Owner’s Manual · December 2011 Page 43
Periodic Maintenance Requirements Maintaining Units
Periodic Maintenance Requirements
Changing CRIND Device Printer Paper
This section provides instructions for cleaning and changing paper for the following CRIND
device printers:
• M00317A00X
• M04119A001: USB Printer that is affixed to the door and can accommodate paper rolls of
up to 4 inches in size.
• M06972A001: USB Sliding printer that can accommodate paper rolls of up to 6 inches in
size.
These printers can be distinguished by identifying the large blue colored mounting screws
(pins) that are found only on the M04119A001 and M06972A001 printers.
Figure 5-1: USB Printer with the Blue Mounting Pins
Blue Mounting Screws
Avoid contacting the gears on the side of the printer with fingers or
hair as it could result in an injury.
CAUTION
When the units are wet or when it rains, avoid changing paper for units without
overhead canopies. If this cannot be prevented, use a dry rag to wipe off the
moisture from the door area especially around the door edges. Avoid dripping
water on the printer or other electronic components when opening the door. This
will cause them to fail prematurely as a result of corrosion.
CAUTION
Ensure that you follow the correct set of instructions based on the type of printer.
To Next Page
Loading...
Need help?
General