Fujitsu ScanSnap S1100 - System Requirements

System Requirements
21
System Requirements
The system requirements for the ScanSnap are as follows:
■ Windows
*1: Service Pack 1 or later required
*2: Service Pack 3 or later required
*3: When the font size is large, some screens may not be displayed properly.
In that case, use a smaller font size.
*4: When using a USB 3.0 port, data is transferred at the same speed as USB 2.0.
Operating system
Windows 7
(32 bit/64 bit)
Windows Vista (*1)
(32 bit/64 bit)
Windows XP (*2)
(32 bit)
CPU
Intel
®
Core™ 2 Duo 2.2 GHz or higher recommended
(minimum: Intel
®
Pentium
®
4 1.8 GHz)
Memory
32 bit: 1 GB or more
64 bit: 2 GB or more
512 MB or more (1 GB or more recommended)
Display
resolution
800 × 600 pixels or higher (*3)
Hard disk space
Disk space required to install the software bundled with the ScanSnap is as follows:
z ScanSnap Manager: 480 MB
z ScanSnap Organizer: 580 MB
z CardMinder: 280 MB
z ABBYY FineReader for ScanSnap: 600 MB
z Evernote for Windows: 120 MB
z Scan to Microsoft SharePoint: 40 MB
USB port (*4) USB2.0/USB1.1
z .NET Framework 3.5 (SP1) must be installed to use Evernote for Windows.
z If .NET Framework 3.5 (SP1) is not installed, it will be installed (500 MB free disk space
required) at the same time when ScanSnap Manager or ScanSnap Organizer is installed.
z Do not use the USB port on the keyboard or the monitor to connect the ScanSnap (it may not
function properly).
z Make sure to use a powered hub equipped with an AC adapter if you are using a
commercially available USB hub.
z If the USB port or the USB hub is USB 1.1, scanning speed will slow down.
z If the CPU or the memory do not meet the required specifications, scanning speed will slow
down.
z The actual increase in used disk space after installation and the required disk space for
installation may differ from each other depending on your Windows system disk
management.
z A disk space approximately three times larger than the resulting scanned file size is required
when scanning documents.