How to Load Documents
30
How to Load Documents
Load a document in the ScanSnap in the following procedure.
For details about documents that can be loaded, refer to
"Documents for Scanning" (page
27)
.
1. Open the feed guide of the ScanSnap.
You can only load one document at a time in the ScanSnap.
z If you want the document to be ejected from the front of the ScanSnap or when there is
not enough space where the document exits the ScanSnap, open the output guide.
For details about documents that can be scanned with the output guide open, refer to
"Documents for Scanning" (page 27).
z How the document is ejected differs as below depending on whether the output guide is
open or closed.
With the output guide closed With the output guide open
To Next Page
Loading...
