Cleaning the Inside of the ScanSnap
364
z Eject roller (× 1)
Press the [Scan/Stop] button to rotate the roller. Gently wipe the dirt and dust off
while taking care not to damage the surface of the roller. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
If eject roller is difficult to clean, try cleaning it from the back while you keep the top
cover slightly open.
6. Close the top cover and the output guide.
It clicks when it returns to its original position.
Pressing the [Scan/Stop] button seven times will rotate the feed roller and the eject roller
one revolution.
Make sure that the top cover is completely closed. Otherwise, paper jams or other
feeding errors may occur.
Output guide
Feed guide
Top cover
To Next Page
Loading...
