FUTABA 14SG - Page 117

116
<Model Menu (Airplane/Glider Functions)>
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
ELEVATOR
(ELEVATOR2)
V-TAIL AILVATOR
FLP3
(BrakeFlap)
FLP4
(BrakeFlap)
RUDDER2
Winglet
RUDDER1
RUDDER
(RUDDER2)
Winglet
atFlyingwing atFlyingwing
()
()
ELEVATOR
ELEVATOR2
(AILERON5)
(AILERON6)
AIL to RUD
This mix is used when you want to coordinate
the rudder with aileron operation for banking at
shallow angles. [Airplane/glider, general]
RUD to AIL
This function is used when you want to mix
the ailerons with rudder input. Rudder is applied
GXULQJUROOLQJPDQHXYHUVVXFKDVNQLIHHGJHÀLJKW
[Airplane/glider, general]
CAMBER MIX
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to CAMBER
This mix is used when you want to the mix
FDPEHUÀDSVZLWKHOHYDWRUWRLQFUHDVHWKHOLIWRIWKH
model. [Airplane/glider, 2 ailerons or more]
CAMB.FLP to ELE
This mix is used to correct for changes in attitude
when the camber flaps are utilized. [Airplane/
JOLGHUDLOHURQVÀDSRUPRUH@
BUTTERFLY (Crow)
This function is used to quickly slow the aircraft
and/or reduce the altitude. [Glider, 2 ailerons or
PRUH)O\LQJDLOHURQVÀDSRUPRUH@
TRIM MIX
7KHDLOHURQVHOHYDWRUVDQGÀDSVWULPRIIVHWUDWH
can be accessed by selecting a switch or condition
selection as desired. [Glider, 2 ailerons or more]
AIRBRAKE
This function is used when airbrakes are
necessary when landing or when diving, etc. during
ÀLJKW$LUSODQHDLOHURQVRUPRUH
GYRO
This is a dedicated mix when a GYA Series gyro
is used. [Airplane/glider, general]
V-TAIL
This function incorporates the elevators and
rudder input for use with V-tail models. [Airplane/
JOLGHU9WDLOVSHFL¿FDWLRQV@
AILEVATOR (DUAL ELEVATOR)
This function adjusts the elevators and ailerons
of models with elevator specifications. [Airplane/
JOLGHUDLOHYDWRUVSHFL¿FDWLRQV@
WINGLET
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
VSHFL¿FDWLRQV@
MOTOR
This function adjusts the operation speed when
the motor of an F5B or other such EP glider is
started by a switch. [Airplane/glider, general]
RUD to ELE
This function is used to correct rolling maneuvers
VXFKDVNQLIHHGJHÀLJKW>$LUSODQHJHQHUDO@
SNAP ROLL
This function selects the snap roll switch and
adjusts the amount of servo input. Servo speed can
also be adjusted. [Airplane general]