91
<Functions of Linkage Menu>
ŏ6HOHFWWKHIXQFWLRQ QDPH
DQGUHWXUQWRWKH/LQNDJH
PHQXE\WRXFKLQJWKH
RTNEXWWRQ
2UWKH
HOME/EXITEXWWRQLV
SXVKHG
<SensorTouch™>
RETURN
TELEMETRY
'LVSOD\LQJGDWDIURPWKHUHFHLYHU
This screen displays your choice of data from the
receiver.
Also warnings can be activated regarding
other data from your aircraft. For example, if the
receiver voltage drops, the user can be warned by
an alarm (and vibration).
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest14CH mode can use all the telemetry functions.
*A telemetry function cannot be used for the 2nd receiver of
dual receiver mode. The voltage and Ext voltage of a 2nd
receiver cannot be known with a transmitter.
ŏ6HOHFW>7(/(0(75<@LQWKH/LQNDJHPHQXDQG
DFFHVVWKHVHWXSVFUHHQVKRZQEHORZE\WRXFKLQJ
WKH571EXWWRQ
ŏ3XVKS1EXWWRQWRDGYDQFHWRQH[WSDJH
ŏ[TELEMETRY]FDQEHFDOOHGLIWKHHOME/EXITEXWWRQ
LVSXVKHGIURPDhome screen
6FUROOLQJ
ŏ0RYLQJFXUVRU
ŏ6HOHFWLQJPRGH
ŏ$GMXVWLQJYDOXH
ŏ7RQH[WSDJH
ŏ5HFHLYHU!7UDQVPLWWHU7KH
UHFHSWLRQVWUHQJWKLVVKRZQ
How to see telemetry date
7HOHPHWU\VFUHHQFDQEHFDOOHGLIWKH+20(
(;,7EXWWRQLVSXVKHGIURPWKHKRPHVFUHHQ
2UVHOHFW>7(/(0(75<@LQWKH/LQNDJHPHQX
DQGDFFHVVWKHVHWXSVFUHHQE\WRXFKLQJ
WKH571EXWWRQ
,IHDFKLWHPLVFKRVHQDQGWKH571EXWWRQLV
SXVKHGDQDODUPVHWXSFDQEHSHUIRUPHG
ZLWKWKHPLQLPXPPD[LPXPDIWHUD
WUDQVPLWWHULVWXUQHGRQ
*Receiver voltage can be checked immediately. An optional
sensor will need to be attached to S.BUS2 of a receiver if
you would like to see other information.
*No special setup is necessary if each sensor displayed
is left as in the default setup. Separate sensor ID
is also unnecessary. However, if two or more of
one kind of sensor is used, setup is required in the
"SENSOR" menu.
:DUQLQJ
Do not watch the transmitter screen during
ÀLJKW
<RXPD\ORRVHVLJKWRIWKHDLUFUDIWGXULQJÀLJKWDQGWKLVLV
extremely dangerous. Have an assistant on hand to check
the screen for you. A pilot should NEVER take his eyes off
his aircraft.