FUTABA 14SG - CH Mode of the Receiver; How to Change the Recievers Channel Mode

25
<Before Use>
R7008SB

CH Mode
7KH56%UHFHLYHULVDYHU\YHUVDWLOH
unit. It has 8 PWM outputs, S.BUS and S.BUS2
outputs. Additionally the PWM outputs can be
changed from channels 1-8 to channels 9-14. If
you only desire to use it as an 8 channel receiver
(without S.BUS), it can be used without any
setting changes.
The T1
4SG
has the ability to link to two
56%UHFHLYHUV2QHRIWKHPRXWSXWWLQJ
channels 1-8 and the other outputting channels
9-14 giving you 14 PWM channels. Instructions
for this configuration and S.BUS operation
follow.
>+RZWRFKDQJHWKH56%&KDQQHOPRGH@
3UHVVDQGKROGGRZQWKH/LQN0RGHEXWWRQ
RQWKH56%UHFHLYHU
7XUQWKHUHFHLYHURQZKLOHKROGLQJGRZQ
WKH/LQN0RGHEXWWRQZKHQWKH/('
EHJLQVWREOLQNJUHHQUHGWKHEXWWRQPD\
EHUHOHDVHG
7KH/('VKRXOGQRZEHEOLQNLQJUHGLQRQH
RIWKHSDWWHUQVGHVFULEHGE\WKHFKDUW
EHORZ
(DFKSUHVVRIWKH0RGH/LQNEXWWRQ
DGYDQFHVWKHUHFHLYHUWRWKHQH[WPRGH
:KHQ\RXUHDFKWKHPRGHWKDW\RXZLVK
WRRSHUDWHLQSUHVVDQGKROGWKH0RGH
/LQNEXWWRQIRUPRUHWKDQVHFRQGV
2QFHORFNHGLQWRWKHFRUUHFWPRGHWKH
/('ZLOOFKDQJHWRDVROLGFRORU
3OHDVHF\FOHWKHUHFHLYHUVSRZHURIIDQG
EDFNRQDJDLQDIWHUFKDQJLQJWKH&KDQQHO
0RGH
Receiverconnector
Settingchannel
ModeA
1 〜 8CH
ModeB
1 〜 7CH
ModeC
9 〜 14CH
ModeD
9 〜 14CH
1 1199
2221010
3331111
4441212
5551313
6661414
7/B 7 7 - -
8/SB 8 S.BUS - S.BUS
RedLEDblink 1time 2time 3time 4time
R7008SB CH MODE TABLE
Danger
Don't touch wiring.
* There is a danger of receiving an electric shock.
Do not short-circuit the battery terminals.
* A short circuit across the battery terminals may cause
DEQRUPDOKHDWLQJ¿UHDQGEXUQV
Please double check your polarity (
＋
and
−
) when hooking up your connectors.
* If
＋
and
−
of wiring are mistaken, it will damage,
ignite and explode.
Don’t connection to Extra Voltage before
turning on a receiver power supply.