FUTABA 14SG - Link Procedure

37
<Basic Operation>
Link procedure (T14SG/R7008SB)
(DFKWUDQVPLWWHUKDVDQLQGLYLGXDOO\DVVLJQHGXQLTXH,'FRGH,QRUGHUWRVWDUWRSHUDWLRQWKHUHFHLYHU
PXVWEHOLQNHGZLWKWKH,'FRGHRIWKHWUDQVPLWWHUZLWKZKLFKLWLVEHLQJSDLUHG2QFHWKHOLQNLVPDGH
the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used
with another transmitter. When you purchase additional R7008SB receivers, this procedure is necessary;
otherwise the receiver will not work.
Link procedure
3ODFHWKHWUDQVPLWWHUDQGWKHUHFHLYHU FORVH
to each other within half (0.5m) meter.
2. Turn on the transmitter.
3. Select [SYSTEM] at the Linkage menu and
access the setup screen shown below by
touching the RTN button.
4. When you use two receivers on one model,
you must change from [SINGLE] to [DUAL].
*Only two receivers can be used. In
"DUAL", two setting items come out. Input,
respectively.
)ZLOOEHFKRVHQLILWLVXVHGLQ)UDQFHRWKHUV
"G" general.
6. When changing battery fail-safe voltage
from the initial value 3.8V, voltage is
changed here.
2QO\LQ)$667HVW0RGH
7.[LINK] is chosen by scrolling and the RTN
button is pushed. The transmitter will emit a
chime as it starts the linking process.
8. When the transmitter starts to chime, power
on the receiver. The receiver should link to
the transmitter within about 1 second.
9. If linking fails, an error message is displayed.
Bring the transmitter closer to the receiver
and repeat the procedure above from Step 2.
10. ACT will be chosen if telemetry is used.
It is INH when not using it.
Lessthan0.5m
In"Link"Mode
ReceiverON
:You can do this through the LINKAGE Menu
and scroll to System and press RTN.
dthith hthLINK
,'RID3ULPDU\
receiver displays.
In DUAL, a primary receiver
is link previously. Next, a
secondary receiver is link.
ID of a Secondary
receiver displays.